Arrakis Systems X-mixer-14-14 Manuel Page 36

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 68
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 35
I N S TA L L A TI O N I N S T R U C TI O N S
Talkback to another Studio
STEP 9- TALKBACK
The Talkback feature is designed so that a console can easily communicate with another studio. In the ARC-10 studio, the operator pushes the TALK button on
mic channels One or Two and speaks through his control room mic into the Monitor/cue system of the other studio. The second studio responds back to the
ARC-10 studio and the audio is heard through the CUE system.
INSTALLATION
The ARC-10 has a talkback audio output to be sent to the remote studio and an audio input to the Cue system (with logic) to receive audio from the remote
studio. All connections are made to the 15 pin, D-sub LOGIC connector on the rear of the console. On site installation requires the building of a custom cable to
link the console to the studio at the other end.
a) TALKBACK INPUT
- on the 15 pin D-sub LOGIC connector, (refer to 4.14 for pin number)
b) INPUT LOGIC- on the 15 pin D-sub LOGIC connector, (refer to 4.14 for pin number)
+12VDC to enable autocue into the headphones.
(If logic is not used, then the talkback will appear in the Cue speaker only)
c) TALKBACK OUTPUT-
on the 15 pin D-sub LOGIC connector, (-10dBu, unbalanced, analog), (refer to 4.14 for pin number)
d) OUTPUT LOGIC- None
OTHER CONSOLES
Talkback can be accomplished between non ARC-10 series consoles and studios. Care should be taken to assure compatibility between logic voltages.
GROUND LOOPS AND HUM
Because of long cable lengths between studios, it is possible for the talkback system to introduce hum into one or both studios. Isolation transformers may
be required on the analog inputs and outputs.
FACTORY CABLE
Arrakis has an optional cables available in various lengths from the factory.
TEST
Test talkback between the two studios. It is important to also listen for hum or noise in the Program output on the control room monitor speakers.
STEP 9- TALKBACK
Logic
RS232
DC Power
Cue
Ch 9
In
Phone
Logic
Pgm Left Pgm Rght Phone Ch 10 Phone
Out Out Out In
PC
USB
Mic 1
In
Mic2
InIn In In In In In
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
48V
pwr
Ch 9
Out
Pgm
Out
Aud
AMM
PMM
Out
Mon
In
Mon
In
Back panel Diagram for ARC-10U (unbalanced base model) & ARC-10UP (unbalanced with PC model)
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
In In In In In In
ARC-10BP (balanced with PC model)
RJ45 balanced
audio connectors
LOGIC connector with
talkback in-out and logic
4.10
Vue de la page 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Commentaires sur ces manuels

Pas de commentaire