Arrakis Systems MARC-15 Manuel Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
I N S TA L L A TI O N I N S T R U C TI O N S
Headphone Wiring
The console has a built in headphone amplifier that will drive hi impedance headphones and 8 ohm headphones. The head-
phone jack for the amplifier is located at the bottom right of the output module (front right corner of the console). The console also
has a balanced line level output for use with an external headphone amplifier. The balanced output is located on the output module on
an RJ45 connector.
WARNING- do NOT have all levels controls at maximum. Too much audio level through your system can damage the headphones.
Audio power amp
4.10
Main Console Outputs
Monitor Inputs and Outputs
Output Module (MARC-OB)
HUM OR NOISE IN THE HEADPHONES
It is possible to get hum with only the headphone amp itself connected
to the console. This is not a problem with the console. It is caused by a
ground loop between the headphone amp and the console power.
A ground loop is created whenever there are two or more ground
paths between two pieces of equipment. This creates a large loop
antenna which detects 60 cycle AC as a hum. Be certain to place both
pieces of equipment on the same AC power strip. If hum persists, then
it is in the audio wiring. Shield grounds connected at both ends of the
cable often are the second ground path. The shield should be grounded
at one end only. To find a ground loop, unplug audio cables one at a time
until the hum goes away. Once the offending cable is isolated, examine
the wiring to find how the loop is being created. Break the loop.
TOP REAR VIEW OF THE OUTPUT MODULE
1
2
3
4
5
6
7
8
Left (+) out
Left (-) out
Right (+) out
Ground
nc
Right (-) out
nc
nc
Monitor Output
1
2
3
4
5
6
7
8
Left (+) out
Left (-) out
Right (+) out
Ground
nc
Right (-) out
Cue out to amp
nc
Earphone Output
1
2
3
4
5
6
7
8
Left (+) in
Left (-) in
Right (+) in
Ground
nc
Right (-) in
Left -10dBu input
Right -10dBu input
External Monitor In
1
2
3
4
5
6
7
8
Mute Relay
Mute Relay
Cue Input (-10dBu)
nc
Talkback (12V)
Talkback (logic)
(+) Talkback in
(-) Talkback in
Miscellaneous IO
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 81 82

Commentaires sur ces manuels

Pas de commentaire